Head Bolts and Studs. Renew bolts: Yes. Stage 1 Tighten 40Nm. Stage 2 Tighten 90°. Stage 3 Tighten 90°. This is the tightening order for the 10 head bolts/studs. ARP offer two different options for the 1.8T head. They had a standard bolt option or there is the stud and nut.
Following my pre-MOT checks, where I detected some play in the lower ball joint, I am replacing the driver side front lower wishbone. A job that isn’t compli
Torque the slide pins as follows: TMC made (Japan): Torque the caliper slide pin 25 ft-lb (34.3 Nm) TMMK made (Kentucky): Torque the caliper slide pin 34 ft-lb (47 Nm) Fill the master cylinder with new clean brake fluid. Pump the brake pedal several times to seat the brake pads. Install the rear wheels.
Hi All, would anybody happen to have or know the torque settings and tightening sequence for the rocker cover and inlet manifold for my 2009 Ford Focus 2.0 TDCi 136ps please, regards Paul.
Car is a focus mk2.5. What is the right torque setting on these wheel nuts? Haynes had a few but couldn't work out which applied to mine. Picture attached. Second question. I tested my antifreeze which has never been changed since i'be owned the car (4 years) and it came back with up to -15 degrees protection.
. 124 317 256 26 411 409 310 230

ford focus mk2 torque settings